NEWS


Requirements for rechargeable batteries for electric aerial work platforms


Time:

2024-11-09

The requirements for using electric aerial work platform rechargeable batteries include the following:

The requirements for using electric aerial work platform rechargeable batteries include the following:

Preparation before charging:

1 Lower the aerial working platform to the ground to ensure stability and prevent tilting or falling off during charging.

2Check whether the voltage and current of the charging power supply meet the requirements of the aerial working platform to ensure that the charging process will not be overloaded or have other power problems.

3Check whether the connection status of the charger and the battery is good to ensure that the current and voltage of the charging process can be transmitted normally.

Risk prevention measures in the charging process:

1The power must be cut off when charging, and it is forbidden to connect wires privately to prevent accidents such as fire and electric shock. At the same time, prevent charging in rainy days, windy days and other bad weather.

2Ensure that there are no flammable substances around the charging process, and keep away from fire and heat sources to avoid causing fire or other safety accidents.

3The charger and battery should be placed in an open, ventilated place, moisture-proof, dust-proof, sun-proof, cold-freeze-proof, etc., to ensure their normal operation.

Precautions during the charging process:

1There should be someone to guard the charging process to prevent external interference and accidents.

2 in the charging process, pay attention to observe whether the temperature of the battery is too high, every 15 minutes to observe, if more than 35 , should stop charging, wait for the battery to cool down before continuing to charge.

3After the charging process is finished, the charger power switch should be turned off in time, the charging plug should be unplugged, and the circuit should be cut off to ensure the safety of the charging process.

Return to List →
Submit
%{tishi_zhanwei}%